50
Replacement Procedures
Service Manual
SKOPE OD400
‐
2
Condenser
Fan
The condenser fan assembly is made up of a fan blade, a motor and a
bracket. The motor is attached to the bracket fixed onto the condenser coil
shroud. When viewed from the inside of the refrigeration unit (motor end),
the motor and blade should rotate in a clockwise direction and pull air
through the front of the refrigeration unit.
To replace the condenser fan motor
1. Remove the front kick panel and isolate the chiller from the power supply (see
2. Remove the refrigeration unit (see page 49).
3. Remove the lid from the unit junction box and trace the condenser fan flexible
cable to the terminal within the unit junction box. Detach the condenser fan
motor flexible cord terminals from the terminal block and capacitor.
4. Detach the condenser cover (side
and top including unit junction
box) by removing the fixing
screws and swivel the cover to the
side. It may be necessary to free
up wires and capillaries inside the
unit junction box to allow
movement.
5. Remove the fan bracket (with fan
motor and blade attached) by
undoing the two fixing screws on
the outside of the bracket and
unslotting the inside of the
bracket.
Note:
Access can be made easier
by undoing the evaporator box
fixing plates and moving the
evaporator box up and out of the
way.
6. Detach the condenser fan motor from the motor mount and fit the
replacement motor.
7. Reassemble the refrigeration unit and test. When reassembling the
refrigeration unit ensure:
The fan blade is reattached the correct way around.
All wires are attached to the correct terminals within the unit junction box.
The condenser fan guard is reattached.
The evaporator box is reattached.
Condenser fan
bracket
