7
SKOPE OD1100N
Installation
Service Manual
The four top shelves are held in place by two cantilevered shelf brackets which clip into cut-
outs in the cabinet back duct. The top four shelves can be adjusted at 28 mm increments (see
image below).
Procedure 1: To reposition a shelf
1. Disconnect the cabinet from the power supply (see page 18).
2. Remove product from the shelf that is being moved.
3. If present, lift the gravity feed matting from the shelf and remove from the cabinet.
4. Unplug the shelf light cable at the inside of the
right hand shelf bracket.
5. Lift the shelf up off the brackets and remove from the cabinet. Be careful not to damage the shelf
light cable.
6. Unwind the cable from the back of the shelf bracket.
7. Select the new position and move the shelf brackets. The shelves can be repositioned as far as
the shelf light cable reasonably allows.
8. Place the shelf, and if present the gravity feed matting, onto the shelf brackets. Ensure the back
of the shelf clips over the rear of the brackets.
9. Push the cantilevered brackets outwards until
they clip into the edge locating slots on the
side of the shelf.
10. Take up any excess shelf light cable by winding it through the two holes at the rear of the shelf
bracket, and reconnect the shelf light cable plug. Make sure that the plug is securely attached to
the correct socket.
11. Reconnect the cabinet to the power supply, and check for correct operation.
Position for
level shelves
Position for
angled shelves
Excess shelf light
cable holes
Shelf light cable plug
Shelf bracket
Adhesive cable clips
Locating slot
Shelf
Shelf
bracket
