22
Replacement Procedures
Service Manual
SKOPE OD1100N
Lighting
The cabinet is fitted with shelf lights. The lights turn on and off automatically when the night
blind is opened or closed. The lights can also be switched on and off manually by pressing the
light button on the electronic controller faceplate (see “Controller Faceplate” on page 10). Note
that the controller is only accessible once the kick panel has been removed.
Shelf Lights
The shelves are fitted with lights at the front of each shelf. The lights are connected to the
power supply by cables which run under the right hand side of each shelf. The cables are fitted
with plugs which must be disconnected when moving the shelves or replacing the lights.
Procedure 11: To remove the side cladding
1. Remove the kick panel
(see page 19), and sign (see page 20).
2. Undo the fixing screws on the back edge of
the side cladding and cabinet top, and lift the
panel off the cabinet, detaching the cladding
from the hook at the front.
Hook
Bottom shelf light
Shelf lights
Procedure 12: To replace a shelf light
1. Disconnect the cabinet from the power supply (see page 18).
2. Remove product from the shelf. If present, lift the gravity feed matting and dividers from the shelf
and remove from the cabinet.
3. Unplug the light and remove the shelf from the cabinet (see page 7).
4. Replace the light by sliding it out of the side of the shelf, and sliding the new light in.
5. Refit the shelf and connect the light cable plug. Make sure that the plug is securely attached to
the correct socket.
