Page 22
770-300M Issue E
www.skcltd.com
Sampling With the Split2 Monitor
To clear the low battery screen press enter and the display will return the main menu screen.
When the battery voltage drops below approximately 6.5V the Split2 monitor will automatically
switch to Standby mode.
4) Finish Sampling
At the end of the sample period press the enter key to stop sampling and the display will
return to the main menu screen. If sampling in Active (pumped) mode stop the air sample
pump.
Remove the equipment from the worker.
If taking a concurrent filter sample transfer the equipment to a clean, dust free environment.
Check the flow rate (refer to page 15 for details) and note the flow meter reading for use in
the calculation of the dust concentration. Remove the sensor head from the bracket. Unscrew
the IOM sampler body from the rear of the sensor head and remove the filter cassette from
the IOM body for post-weighing. If the filter sample is to be sent for subsequent analysis fit
the red cassette cap to the cassette inlet and place the cassette into the red cassette clip
supplied in the Split2 monitor kit.