Use and Maintenance Manual
–
002.108A of _27/09/2021
Square Baler
–
M 60 Mini/S
–
M 60 Mini
–
M 60 Super
33
ENGLIS
H
5.7 Maneuvers at the end of the row
At the end of the row, when the swath is finished, slow down the PTO speed, turn with a large radius
to get in position for a new swath, increase the PTO rpm to full speed and continue baling.
If you need to make a tight turn, stop the rotation of the PTO in order to prevent damaging the PTO
shaft; (a homokinetic PTO shaft, which allows maneuvering with a smaller turning radius, is
available as an accessory).
If necessary, move in reverse in order to get aligned with the swath.
DANGER
While maneuvering at the end of the row, make sure that there are no persons or objects in the danger
zones that can be injured or damaged by the machine - there is danger of death or serious injury.
ATTENTION
The machine maneuvers are different for turning left or right, therefore it is necessary to have
adequate experience to maneuver the machine.
CAUTION
Turning too tightly causes the tractor wheel to come into contact with the PTO shaft or the tongue;
avoid this situation, because it may cause damage to the machine or injury to persons.
5.8 Setting up for the transport position
1) Remove the PTO shaft from the machine (Do this with the engine off, the parking brake engaged
and the key removed from the ignition).
2) Put a chock behind the right wheel.
3) Pull the lever to release the drawbar (or pull the lever from the tractor by means of cable 5).
4) Move the tractor in reverse, causing the drawbar 6 to move to the
“
drawbar closed
”
position.
5) Release the lever to lock the drawbar in the
“
drawbar closed
”
position
(or release the lever from the tractor by means of cable 5).
See Fig. 5.11.
