Use and Maintenance Manual
–
002.108A of _27/09/2021
Square Baler
–
M 60 Mini/S
–
M 60 Mini
–
M 60 Super
55
ENGLIS
H
7.4 Knotter adjustment
There are several possible knotter adjustments, and they are generally necessary only when there is
wear on the components.
7.4.1 Knotter brake adjustment
This brake (ref. 7 Fig. 7.11) is designed to make the motion of the knotter uniform during the tying
cycle and to hold it still when it is not working.
The adjustment is done by turning the adjustment screw to increase or decrease the compression on
the spring 3 (Fig. 7.11). The reference measure H = 25 mm.
ATTENTION: do not fully compress the spring, as this will stop the movement of the knotter and
possibly cause the breakage of the shear bolt.
Fig. 7.11
Tighten the screw if the needles move during compressing; loosen the spring if the knotter is blocked
during the tying stage.
