Use and Maintenance Manual
–
002.108A of _27/09/2021
Square Baler
–
M 60 Mini/S
–
M 60 Mini
–
M 60 Super
56
ENGLIS
H
7.4.2 Holder disc pressure adjustment
To find the correct holder disc pressure, proceed as follows: the twine must be inserted and pressed in
the holder disc. Adjust the spring 1 in Fig. 7.12 as described previously, so that the twine runs only
when subjected to a force F of 40 to 60 kg. If necessary, adjust the flat spring 1 (Fig. 7.12) until the
distance A is approximately 2
–
3 mm.
ATTENTION! The twine knotter compartment must be blown out and cleaned at least once a day to
avoid the clogging and jamming of parts that may prevent them from functioning properly (for
example: the crescents control shaft, the straw trap pawls, etc.)
ATTENTION! If the knotter is uncovered during use, the operator must be very careful to avoid any
possible risk.
Fig. 7.12
Make this adjustment with 1/3-1/2 of a turn for each attempt.
The pressure of the holder discs must hold the twine pulled taut by the proceeding of the bale, but at
the same time it must allow the knotter billhooks to extract the amount of twine necessary to form the
knots.
The pressure is adjusted by adjusting the flat spring 1. To do this, loosen the lock nut 3 and turn the
screw 2 (Fig. 7.12).
