EN
6/8
T3.5 EHz DC FUNCTIONING
6
6.1
- With a well charged battery, the possible commands are: Up, Stop and Down.
- The motor slows down at the UP & Down end-limit.
- The motor will start with a slower speed after a “UP” order starting from the Down end-limit position.
- It is also possible to set an intermediate position (see §7).
6.2
-
Frost detection function
: The motor stops if the shutter is stuck by ice during opening.
6.3
-
Obstacle detection function
: When closing the shutter if the motor is stuck by an obstacle, the motor will
stop & then run in the reverse direction.
6.4
-
Battery protection against excessive discharge
: Before each downward or upward movement of the
shutter, the motor checks the voltage of the battery:
-
If the voltage is below 12V: It would not be possible to perform the programming of the motor (§2 -> §9).
-
If the voltage is below 11,5V: The motor will pause at the beginning of each command to lift the shutter. The
shutter can only be closed by pressing several times on the «down» button.
-
If the voltage is below 10V: The motor won’t accept any order.
i
In these cases, use the battery charger in order to perform a quick battery recharge. Operation of the
motor will go back to normal only if the battery voltage reaches above 12V.
WARNING: Never leave a battery discharged (the battery can be damaged by being left in a discharged
condition for an extended period).
RECORDING / CONTROLING / DELETING INTERMEDIATE POSITION
7
Recording:
- Move the motor to the wanted
position.
- Press
5 seconds
on the
« STOP » button. The motor
will run for 0,5 second in one
direction and then in the other.
5 s
Control:
- Press the
« STOP »
button for
0,5 second.
The motor runs to the
intermediate position.
0,5 s
Deleting:
Position the motor on the intermediate position. Press 5 seconds on the “Stop” button, the intermediate
position is deleted.
