EN
3/8
2.2- Checking the rotation direction:
Press the “UP” button of the transmitter :
a-
If the motorized tube runs in the Up direction, move to next stage 2.3.
b-
If the motorized tube runs in the Down direction, reverse the rotation direction by pressing the
“STOP”
button
for at least
3 seconds
. The motor will run for 0,5 second in one direction, then in the other direction.
Move to the
stage 2.3.
2.3- End limit adjustment:
The end limits of the T3.5 EHz DC are adjusted in 4 different ways depending on the following conditions : Bottom
slat stop or not, rigid* or flexible link between the rolling shaft and the shutter.
A
* V.A.R
V.A.S
Easylink
OctoEasy
B
* V.A.R
V.A.S
Easylink
OctoEasy
C
D
1-
Simultaneously press the “UP” and “DOWN” buttons
of a Hz transmitter. The motor will run for 0.5 second in one
direction and then in the other.
2- Press the
“STOP” button for 2 s
. The motor will run
for 0.5 second in one direction and then in the other.
The
operation is completed. Go to step §3.
B
1
2
3
2 s
4
1- Position the motor on the Up end limit by using the buttons “UP” or “DOWN”.
2- To memorize the UP end limit position, press simultaneously the buttons
“STOP” and “DOWN”
. The motor will
run automatically in the down direction.
3- Press the “STOP” button to immobilize the motor.
4-
Press 2 seconds the “STOP”
button to validate the setting. The motor will run for half a second in one
direction, then in the other direction.
The operation is completed. Go to step §3.
a
>>
>> OK >> 2.3
b
>>
>>
3 s
>> OK >> 2.3
2 s
A
1
2
