MX575A/B DGPS Compass
19
Figure 21
-
Connected Power / Data cable
The next step is to fasten the MX575
enclosure to the pole mount base using the
supplied self-tapping screws. The following figure illustrates this process. There
are two alignment keys on top of the base that must fit into two holes of the
MX575
enclosure. Once you have aligned the base, use a screwdriver fitted with
the supplied Torx T20 bit to fasten the base to the enclosure using the supplied
screws. These screws self tap a thread in the blind screw holes of the enclosure.
Fasten the screws firmly, but be careful not to strip the thread.
Note: The base is not intended to be removed and re-fastened frequently. Frequent removal of
the base from the enclosure may result in failure of the screw hole threads. Stripped threads
are not covered under the product warranty.
