MX575A/B DGPS Compass
12
Once you have secured the connector, slide the fixed base up to the bottom of the
MX575 enclosure. There are two alignment keys on top of the base that must fit
into two holes of the enclosure. Once you have aligned the base, use a
screwdriver fitted with the supplied Torx T20 bit to fasten the base to the enclosure
using the supplied self-tapping screws. Fasten the screws firmly, but be careful
not to strip the thread.
The following two figures show the location of the screw holes.
Figure 11- Fastening the fixed-base to the MX575
Figure 12
-
Fastening the fixed-base to the MX575
