Operating the Tractor
Driving The Tractor
1. Sit in the seat and adjust the seat so that you can
comfortably reach all the controls and see the
dashboard display.
2. Engage the parking brake.
3. Make sure the PTO switch is disengaged.
4. Start the engine (see STARTING THE ENGINE).
5. Disengage the parking brake and release the brake pedal.
6. Depress the forward ground speed control pedal to travel
forward. Release the pedal to stop. Note that the further
down the pedal is depressed the faster the tractor wil travel.
7. Stop the tractor by releasing the ground speed control
pedals, setting the parking brake, and stopping the engine
(see STOPPING THE TRACTOR AND ENGINE).
Mowing
1. Set the mower cutting height to the desired level and set the
gauge wheels to the appropriate position (if equipped).
2. Engage the parking brake. Make sure the PTO switch
is disengaged.
3. Start the engine (see STARTING THE ENGINE).
4. Fully lower the mower using the attachment lift lever and set
cutting height.
5. Set the throttle to FULL.
6. Engage the PTO (Mower Deck).
7. Begin mowing.
8. When finished, shut off the PTO and raise the mower using
the attachment lift control lever.
9. Stop the engine (see STOPPING THE TRACTOR
AND ENGINE).
Mowing in Reverse
DO NOT TOW TRACTOR
Towing the unit will cause transmission damage.
• Do not use another vehicle to push or pull this unit.
• Do not actuate the transmission release valve lever
while the engine is running.
Figure 3. Transmission Release Lever & Fuel Tank
A. Fuel Tank Cap
B. Transmission Release Lever
B
A
If an operator chooses to mow in reverse, the RMO system can
be used. To use the Reverse Mowing Option (RMO) turn the
RMO key after the PTO is engaged. The L.E.D. light will
illuminate, and the operator can then mow in reverse. Each time
the PTO is engaged the RMO needs to be reactivated if desired.
The key should be removed to restrict access to the
RMO feature.
Attachment Operation in Reverse
If an operator chooses to operate a PTO driven attachment in
reverse, the RMO system can be used. To use the Reverse
Mowing Option (RMO) turn the RMO key after the PTO is
engaged. The L.E.D. light will illuminate, and the operator can
then operate the attachment in reverse. Each time the PTO is
disengaged the RMO needs to be reactivated if desired. The
key should be removed to restrict access to the RMO feature.
Pushing the Tractor by Hand
1. Disengage the PTO and turn the engine off.
2. Pull the transmission release (B, Figure 3) back
approximately 2-3/8” (6 cm) to lock into released position.
3. The tractor can now be pushed by hand.
16
WARNING
The engine will shut off if the reverse ground
speed pedal is depressed while the PTO is on
and the RMO has not been activated. The
operator should always turn the PTO off prior to
driving across on roads, paths or any area that
maybe used by other vehicles. Sudden loss of
drive could create a hazard.
WARNING
Mowing in reverse can be hazardous to
bystanders. Tragic accidents can occur if the
operator is not alert to the presence of children.
Never activate RMO if children are present.
Children are often attracted to the unit and the
mowing activity.
Not
for
Reproduction
Summary of Contents for Regent Series
