EA230-K-30 – Functions
Operating Manual
Chain actuator – EA-K-30/xxx-T(-DA)
Chain actuator
– EA230-K-30/xxx(-S)
BA_EA(230)-K-30-XXX_EN_12
www.simon-protec.com
Date: 13.02.2019
Issue: 1.2 / 01.2019
Page 8
4.3 Configurable ranges
Soft-close range: moves with the electronic zero point, the soft-close current I
SC
and the speed reduction can be configured via
SIMON LINK.
Reset range: the electronic zero point is reset when switching off via load in direction of the “CLOSED” driving direction within the
first 30 mm before the “CLOSED” end position.
Stroke: electronic stroke limitation depending on programming.
Figure 10: Configurable ranges
5. EA230-K-30 – Functions
5.1 End position cut-off while closing
The end position cut-off while closing occurs automatically
(load depending) and is not programmable. The electronic
switches off the actuator, when reaching a threshold value, if,
for example, the window is completely closed and moved into
the gaskets.
After the window is closed each time or the cut-off current has
been exceeded, the chain is extended slightly again to protect
the gaskets and the window.
5.2 End position cut-off while opening
The cut-off in the OPEN end position occurs automatically
and can be set with the DIP switches 1-2.
A teach-in run must be performed after setting the DIP
switches (three switch combinations for the STROKE setting).
5.3 DIP switches
(See Figure 2: “EA230-K-30/xxx(-S) chain actuator” on page 5.)
mechanical ]HUR
electronical ]HUR
mechanical “max”
30 mm
75 mm
reset
range
soft-closerange
electronical stroke
50 mm
stopping time 3 s
stopping time 3 s
50 mm
before max. electr. stroke
stopping time 0 s
ATTENTION
The actuator must be de-energised before the DIP
switches can be changed. After setting the DIP switches, a
pause of approx. 5 seconds must be observed before the
drive can be supplied with power again.
DIP
switch 1
DIP
switch 2
Function
ON
ON
Maximum stroke
(delivery condition)
OFF
ON
STROKE reduced by 100 mm
ON
OFF
STROKE reduced by 200 mm
OFF
OFF
RESET
(See chapter 5.4 “RESET” on
page 9)
