Simex MultiCon CMC-N16, User Manual

Page: 89 / 292

User Manual For - CONTROLLER/DATA RECORDER MultiCon CMC-N16
see Fig. 4.7.
Fig. 7.47. The view of a sample list of available hardware inputs for a device
In the device there are two methods to change the source configuration of the
Built-in inputs
:
•
using the Configure source button in the Logical channel menu in
the Hardware input mode,
•
using the Built-in inputs menu,
The
Source
for the
Hardware input
mode can be (in the same order as the list in the device -
see
Fig. 7.47
):
a) installed hardware input configurations in the appropriate blocks A, B or C (see
Fig. 4.8. ) - the list of currently available configurations is on the website,
A description of the hardware input configurations parameters is shown in Chapter 7.9.2.
Built-in inputs - Hardware input configurations
.
The following steps change the Source configuration for the sample of 3 hardware
configurations shown in Fig. 7.48 :
– Step (1) - selection of the Source for the channel in the Hardware input mode, for
example: Inp.A1:Current , next press the Configure source button to enter
the
Source configuration
menu,
– Step
(2)
- press the
Mode
button to change the range of the current input,
– Step (3) - choose from the list of available options for the signal range - for example:
Current 0-20mA (for the current hardware configuration),
89
i
Hardware configuration
FUN2
2 current inputs
Built-in
binary input
Built-in
demo input
Block A - Input 1
Block X (built-in block)
input 4