GB
│
IE
│
NI
│
CY
│
11
■
SEM 1100 D3
7) As soon as the white “Espresso” control lamp
t
lights up continuously,
press the “Espresso” button
3
. Let the water run through for about 1
minute .
NOTE
►
You may need to empty the cup in between . Interrupt the process by pressing
the "Espresso" button
3
. Empty the cup and press the "Espresso" button
3
again so that water flows through the appliance .
8) After about 1 minute, stop the pump by pressing the “Espresso” button
3
again .
9) Wait until the “Espresso” control lamp
t
lights up continuously (if it is not
already lit) . The warming-up is concluded . You can now prepare espresso .
Heating up before every use
Before preparing an espresso or cappuccino, heat up and rinse the machine .
1) Switch the appliance on using the On/Off switch
1
. The red operating
lamp
z
lights up . The “Espresso” control lamp
t
flashes white . Make sure
that the steam control
7
is turned in the direction of the “ ” as far as the
stop .
2) Place the sieve holder
i
in the appliance by inserting the “INSERT” mark,
which is located next to the hot water shower
r
, into the appliance and then
turning it clockwise until the handle of the sieve holder
i
is facing the front
(“
I
” mark) .
3) Press the “Espresso” button
3
so that the appliance draws water from
the water tank
9
. As soon as water starts exiting the openings in the sieve
holder, press the “Espresso” button
3
again to stop the pump .
4) Wait until the “Espresso” control lamp
t
lights up continuously .
5) Press the “Espresso” button
3
again and allow hot water to flow
through for 20 seconds before stopping the pump again .
The preheating process is completed . You can now make an espresso/cappuccino .
NOTE
►
If you want to prepare several espressos or cappuccinos in a row, you do
not need to heat up the machine again and rinse it .
Preparing espresso
NOTE
►
Always ensure that the espresso sieve
o p
is clean and free of coffee
powder residues .
