GB
│
IE
│
NI
│
CY
│
9
■
SEM 1100 D3
4) Place the sieve holder
i
in the appliance by inserting the “INSERT” mark,
which is located next to the hot water shower
r
, into the appliance and then
turning it clockwise until the handle of the sieve holder
i
is facing the front
(“
I
” mark) .
5) Insert the plug into a mains power socket .
6) Proceed as follows before the first use, so as to clean the internal pipelines:
Allow sufficient water for about 5 cups of espresso (about 100 ml) to flow
through the appliance . Refer to the section “Operation” .
7) Let the appliance generate steam for about 30 seconds . Refer to the section
“Operation” .
NOTE
►
When using the appliance for the first time, it is possible that you can hear
the pump working, even though no water comes out of the appliance . If this
is the case, turn the steam control
7
in the direction of the “ “, so that the
air can escape from the pipes of the appliance (the "Steam" button
4
is pressed) . After approx . 20 seconds the air will have escaped, the noises
disappear and water flows from the appliance .
Operation
Filling the water tank
NOTE
►
Use only fresh drinking water for making espresso/cappuccino .
1) Remove the water tank
9
and fill it with water:
Fill it with water to at least the Min marking .
Never fill it past the Max marking .
2) Replace the water tank
9
in the machine .
Heating after a long time of inactivity / during first use
If you have not used it for some time, preheat the appliance as follows:
1) Fill the water tank
9
with tap water .
2) Place either the large
o
or the small espresso sieve
p
in the sieve holder
i
:
–
Make sure that the small indentation on the large
o
or small espresso
sieve
p
is located above the indentation on the sieve holder
i
when
inserted (fig . 1) .
