Silicon Graphics Origin 300, User Manual

Page: 238 / 264

212 007-4498-002
C: System Controller Commands
Example C-49 r
<rack>
s
<slot>
l1 config Command Output
L2> r 1 s 28 l1 config
001r28:
:0 - 001r28
Use the
:
<port>
:
<li>
l1
<cmd> command to send a command to a destination module
that does not have a brick identification number assigned to it yet. In this command, the
variable
<port> is the port number, and the variable <cmd> is an L1 controller command.
l2
Use the
l2
command to engage and lock the L2 command processor. Example C-50
shows sample output from the
l2
command.
Example C-50 l2
Command Output
L2> l2
L2 command processor engaged, <CTRL-D> for console mode.
l2find
The
l2find
command lists all of the L2 controllers that are connected together (refer to
Example C-51).
Example C-51
l2find
Command Output
L2>l2find
13 L2's discovered:
IP SSN NAME RACK FIRMWARE
--------------- -------- ---------------- ---- ------------
[ L2's with System Serial Number NOT set ]
137.38.82.101 000 L3 controlle
137.38.82.102 000 L3 controlle
[ L2's with different System Serial Numbers ]
137.38.82.156 L1000625 001 1.8.0
137.38.82.51 N1000405 itsys1 111 1.7.7
137.38.82.58 L0000002 klsys2 002 1.7.7
137.38.82.159 L0000138 klsys4 004 1.7.9
137.38.82.162 L0000005 klsys5 005 1.7.7
137.38.82.57 L0000007 klsys7 007 1.8.0