208
007-4498-002
C: System Controller Commands
Note:
For these commands, the mnemonics
re
and
man
may replace the words
rescan
and
manual
.
destination
The
destination
set of commands displays the brick identification numbers of
modules that are the destination of L2 commands, or it sets the modules that are the
destination for L2 commands. There are four commands in the
destination
command
set:
•
destination
•
r
<racks>
destination
•
r
<rack>
s
<slots>
destination
•
destination reset
Note:
For these commands, the mnemonic
dest
may replace the word
destination
.
Also, the words
rack
and
slot
may replace the mnemonics
r
and
s
.
Use the
destination
command to view the brick identification numbers of the
modules that are the destination of L2 commands. Example C-42 shows sample output
from the
destination
command.
Example C-42
destination
Command Output
L2> destination
all racks, all slots
Use the
r
<racks>
destination
command to set the racks that are the destination for
L2 commands (this command selects all of the modules in a rack as the destination
modules). In this command, the variable
<racks>
is a rack number, a comma separated
list of rack numbers, or a range of rack numbers indicated by a dash character.
Example C-43 shows sample output from the
r
<racks>
destination
command.
Summary of Contents for Origin 300
