Silicon Graphics InfiniteStorage 6120, User Manual

Page: 29 / 94

Setting Up the InfiniteStorage 6120
0 0 7 - 5 5 3 3 - 0 0 1
19
5. Using two (2) 10-32
×
0.50" (100d) Phillips flathead screws for each CMA, attach the CMA to
the CMA brackets
(Figure 17)
. If the depth of your rack is 25.5 inches (647 mm) or less, attach
the CMA directly to the rack, above the rail kits. For square-hole rack, add 100d #10 shoulder
washers.
6. With the help of a partner, hold the chassis close to the rail kits. Align the rear flanges on chassis
with the rail kit flanges
(Figure 17)
and slide the chassis into rack until the sliders are engaged
(slide in about 12 inches until stopped). Then slide the chassis out until locked. Depress the
slider locks and proceed to slide the chassis all the way in.
7. Secure the two CMA to rear of chassis with two (2) 8-32
×
0.25" Phillips panhead screws.
Attach CMA with
(2) 10-32x0.50" (100d)
Phillips Flathead Screws
(Add 100d #10 Shoulder Washers
for Square-Hole Rack)
Attach CMA to Chassis with
(2) 8-32x0.25" Phillips
Panhead Screws
Rear Flange on Chassis
Rail Kit Flange
(Rear Flange of Chassis
must set on Rail Kit Flange)
Figure 17. Install Chassis to Rack