Silicon Graphics InfiniteStorage 6120, User Manual

Page: 4 / 94

iv
0 0 7 - 5 5 3 3 - 0 0 1
P r e f a c e
Safety
NOTE : If this equipment is used in a manner not specified by the manufacturer, the
protection provided by the equipment may be impaired.
Caution ! Safety goggles should be worn when maintaining the equipment.
WARNING: The InfiniteStorage 6120 MUST be grounded before applying power.
Unplug the unit if you think that it has become damaged in any way and before you
move it.
Caution ! To maintain proper airflow through the system, operate the system with the
enclosure top covers closed.
• Plug-in modules are part of the enclosure and must only be removed when a replacement can be
immediately installed. The system must not be run without all modules in place.
• In order to comply with applicable safety, emission, and thermal requirements, the top covers
should remain closed while running.
• The InfiniteStorage 6120 system must only be operated from a power supply input voltage range
of 200 VAC to 240 VAC.
• The equipment is intended to operate with two (2) working PCMs. Before removal/replacement
of any module, disconnect all supply power for complete isolation.
• A faulty PCM must be replaced with a fully operational module within 24 hours.
• Do not remove a faulty PCM unless you have a replacement module of the correct type ready for
insertion.
• The power connection must always be disconnected prior to removal of the PCM from the
enclosure.
• A safe electrical earth connection must be provided to the power cord.
• Provide a suitable power source with electrical overload protection to meet the requirements
given in the technical specifications.
WARNING: Do not remove covers from the PCM. Danger of electric shock inside.
Return the PCM to your supplier for repair.
WARNING: To minimize the risk of electric shock, disconnect the
power from the power supply, either by turning off the switch or by
physically removing the power cable, prior to removing the PCM from
the enclosure.