Silicon Graphics InfiniteStorage 6120, User Manual

Page: 26 / 94

Setting Up the InfiniteStorage 6120
0 0 7 - 5 5 3 3 - 0 0 1
16
2.2 Setting Up the InfiniteStorage 6120
This section details the installation of the hardware components of the InfiniteStorage 6120 system.
NOTE : Follow the safety guidelines for rack installation given in Appendix B “Safety
Requirements for Rack Installation”.
2.2.1 Unpacking the InfiniteStorage 6120
Before you unpack your InfiniteStorage 6120, inspect the shipping container(s) for damage. If you
detect damage, report it to your carrier immediately. Retain all boxes and packing materials in case
you need to store or ship the system in the future.
While removing the components from their boxes/containers, inspect the InfiniteStorage 6120
chassis and all components for signs of damage. If you detect any problems, contact SGI Technical
Support immediately.
Your InfiniteStorage 6120 ships with the following:
• InfiniteStorage 6120 controller chassis with integrated controllers
• Two (2) power cables
• One (1) mini-jack serial cable for initial configuration
• One (1) enclosure faceplate
• Rack-mounting hardware
If your controller and disk enclosure configuration is delivered already installed
in the rack, it must be removed from the shipping pallet using a minimum of 4
people. The racked unit may not be tipped more than 10 degrees, either from a
level surface or rolling down an incline (such as a ramp).
Warning
!
Wear an ESD wrist strap or otherwise ground yourself when handling
InfiniteStorage 6120 modules and components. Electrostatic discharge can
damage the circuit boards.
Warning
!