23
Silhouette Cameo® 4 User Manual
Use the Roll Feeder
The built-in roll feeder is located inside a tray at the front of the Cameo 4. To open the roll feeder, gently slide out that
tray completely.
Note: When opened all the way, the roll feeder tray sticks out about 8 inches from the machine. If you find that the tray is
sticking out about only 4 or 5 inches, the tray may be caught and may not be sliding out all the way. Gently continue to pull
on the tray until it is out all the way.
With the tray all the way out, flip open the inserted piece to reveal where you can place the roll feeder. There are two
end pieces you’ll also flip up, and this is where your rolled material will rest. Slide the right end piece to match the width
of your material—either 9 inches or 12 inches.
Place your rolled material on the roll feeder. Take the end piece and feed it through the roll feeder slot. Then feed it into
your machine using the Load button on the touch panel. Make sure the material is feeding straight into the machine.
When you’re finished using the roll feeder, remove the roll of material, fold the pieces back down, and slide the tray back
into place.
Open Roll Feeder
Summary of Contents for CAMEO 4
Page 1: ...User Manual ...
