SII LP-1010, User Manual

Page: 86 / 290

2-44
This device supports the following series of paper.
A series
9 × 12 inch series
8.5 × 11 inch series
30 × 42 inch series
Map series
DIN series
Chinese series
The device is set up when shipped out of the factory so as to support the A
series or A and Chinese series. You can check for which series your
device is currently set up for by the enable series (page 11-5) (any series
having been set to ON can be used).
The steps to add new series are added is described below. The 8.5 × 11
inch series is taken as an example. The process is also applicable to other
series. When using the Chinese series, refer to “When using paper of
China series (page 2-45)”.
(1) Adding new media series
Set the 8.5 series to ON in the enable series screen (page 11-5).
(2) Change the apply roll setting
The 34, 22, 17 and 11-inch rolls can be used for the 8.5 × 11 inch series.
Set the roll to be actually used to ON in the apply roll setting process
(page 11-7).
It is recommended to set other rolls to OFF.
When using only the cut paper of the 8.5 × 11 inch series, this step is not
needed.
Using paper of new standard series
Note
◆
All the series cannot be set to OFF at the same time.
◆
When this setting is changed, the device must be restarted.