22
TIG Welding
1.
Insert the earth cable plug into the positive socket on the front of the machine and tighten it.
2.
Plug the welding torch into the negative socket on the front panel, and tighten it.
3.
Connect the gas line of TIG Gun to outlet gas connector on the front of the machine. Check for Leaks!
4.
Connect the control cable of torch switch to 9 pin socket on the front of the machine.
5.
Connect the water inlet and outlet pipe of TIG Gun to inlet and outlet water connector on the front of
the cooling water.
6.
Connect the control cable of cooling water with the aero socket on the rear panel of welding machine.
7.
Connect the gas regulator to the Gas Cylinder and connect the gas line to the Gas Regulator.
Check
for Leaks!
8.
Connect the gas line to the machine inlet gas connector via the quick push lock connector located on
the rear panel.
Check for Leaks!
9.
Connect the power cable of welding machine with the output switch in electric box on site.
10.
Carefully open the valve of the gas cylinder, set the required gas flow rate.
11.
Select TIG welding mode on the front panel.
12.
Set torch operation 2T/4T.
• When 2T operation is selected press trigger Gas starts, touch and lift arc start, release trigger Gas and
Arc stops.
• When 4T operation is selected press and release trigger Gas starts, touch and lift arc start, press and
release trigger Gas and Arc stops.
13.
Select water cooling mode on the front panel.
DIAGRAM FOR GUN
17
Installation & Operation for TIG Welding
Set up installation for TIG Welding
(1) Insert the earth cable plug into the positive socket on the front of the machine and
tighten it.
(2) Plug the welding torch into the negative socket on the front panel, and tighten it.
(3) Connect the gas line of TIG Gun to outlet gas connector on the front of the machine.
Check for Leaks!
(4) Connect the control cable of torch switch to 9 pin socket on the front of the machine.
(5) Connect the water inlet and outlet pipe of TIG Gun to inlet and outlet water connector
on the front of the cooling water.
(6) Connect the control cable of cooling water with the aero socket on the rear panel of
Summary of Contents for Evolution MTS400 SYN
Page 39: ...39 Notes ...
