Sifam Tinsley Theta 30P, Operating Manual

Page: 23 / 84

*
*
3.1.7.1 Address Setting
This screen applies to the RS 485 output only.
This screen allows the user to set RS485 parameter for instruments.
The
range of address is 1 to 247. allowable
3.1.7: Communication Parameter Setting:
Pressing “ Down” key will advance
to the “
edit” mode. address value
Pressing the “ Up” key will confirm
the present value as address and
advance to Baud Rate selection
(section3.1.7.2).
(*Denotes that digit will be flashing).
Pressing the “ Down” key will
scroll the value of the second digit
from 0 to 2 and the value will roll
Pressing the “ Up” key will advance the operation to the next digit
and set the second digit, in this case to “0”.
Editing Existing Address Value
First digit is always blank.
back again to 0.
After, second digit gets entered, it will
(*Denotes that digit will be flashing).
Pressing the “ Down” key will scroll the
value of the third digit from 0 to 9 and
the value will roll back again to 0 or
second digit set. Pressing the “ Up” key will advance the operation
prompt for third digit.
to the next digit and set the third digit, in this case to “0”.
23
it will get restricted depending on