NL
Malfunctions and how to fix them
Malfunctions
Cause/Solution
The drying result is not
■
At the end of the programme, warm laundry feels damper than it
actually is. Spread the laundry out and let the heat escape.
Excessively high ambient temperature (above 30°C) or insufficient
ventilation in the room where the washer dryer is located. The laundry
has not been spun sufficiently before drying. Always select the highest
possible spin speed for the respective wash programme.
Washer-dryer overloaded: follow the recommendations for the
maximum amount of laundry in the program table and on the load
display. Do not put too much laundry in the washer dryer, because the
maximum load for drying is smaller than that for washing. After
washing, empty the washer dryer with a maximum amount of laundry
and divide the laundry into two drying cycles. The power supply
voltage is too low (less than 200 V) – provide a suitable supply voltage.
The water pressure is low. According to the water condensing principle, a low
water pressure will cause evaporated steam to not condense properly and
completely.
The water tap is closed during drying. Since the water
condensation technique is used for drying, you must leave the
connected water tap open during the drying process; otherwise
correct drying cannot be guaranteed.
Thick textiles, consisting of several layers or with a thick filling,
dries easily on the surface, but not on the inside. As a result,
drying can take more time.
satisfactorily
(laundry is not dry
enough).
■
■
■
■
■
■
■
If you cannot rectify a fault yourself (after turning the program selector (
off)
and turned it back
on) or when a repair is required:
■
Turn the program selector to (
off).
Remove the plug from the socket.
■
Turn off the tap and contact customer service.
54
