NL
Program default settings
0
Program standard
settings
B
Ready in/Drying time
Before the program starts,
You can
the end of the program ("Finish in" time in
steps of 0.5 h (h = hour) between
“minimum selectable end time” and 9.5 h)
or in steps of 1 hour (between 10 h and 24
h) until select a maximum of 24 hours.
Program Default Settings
You can change the default settings
of selected programs. The settings can be
changed even while the selected program
is running. The effects depend on the
progress of the program.
To do this:
1.
Select a program (except
°C Temp.
G
myTime drying*
program).
The program duration becomes
displayed for the
selected program, e.g.
2:30
(hours:minutes).
Before and after the program has started,
you can change the temperature setting,
depending on the phase the program is in,
by setting it to the desired value via the
display.
2.
Select the B
Ready in/Drying time
button repeatedly until the
desired number of hours is
displayed.
The maximum temperature that can
be set depends on the selected
program.
3.
Select the
Start/Refill
knob.
The program starts.
The selected number of hours (eg.
8h)
is displayed on the display panel
and counts down until the program
starts. Then the program duration is
displayed.
0
Centrifuge
Depending on the phase the program is
in, you can change the spin speed before
and during the program by setting it to
the desired value (in rpm; revolutions per
minute) via the display.
Note:
The length of the program is
automatically adjusted when the
program is run. Changes to the
program default settings or additional
program settings can also change the
program duration.
Institution
2: 2 ="Do not spin". The rinse
water is pumped out, but there is no final
spin. The laundry remains wet in the
drum, e.g. for items that are not
may be centrifuged.
After starting the program
(when a “Finish in” time has been selected
and the program has not yet started) you
can change the preset number of hours as
follows:
You can select “No Spin” to avoid creasing
if the laundry is not taken out immediately
after the program has finished.
1.
2.
Select the
Start/Refill
knob.
Select the B
Ready in/Drying time
button repeatedly to change the
number of hours.
Select the
Start/Refill
knob.
The maximum speed that can be set
depends on the model and program
selected.
3.
*
Depending on the model
36
