NL
Malfunctions and how to fix them
Display
Cause/Solution
H:95
alternates with
No water detected in the drying phase can lead to poor drying results.
The filter in the water supply is clogged" on page 47
“Ÿš
when the pro
gram is completed
H:32
alternates with
The load imbalance detection system interrupted the spin cycle because
the laundry was unevenly distributed. Distribute small and large items of
laundry evenly in the drum.
“Ÿš
when the pro
gram is completed
Other Displays
Turn the program selector to (
off),
wait five seconds and turn it back
on. When the display reappears, contact customer service.
Malfunctions and how to fix them.
Malfunctions
Cause/Solution
Water is leaking from the
appliance.
■
■
Fix or replace the drain hose correctly.
Tighten the screw fitting on the supply hose.
The door cannot be
opened.
■
~~~ (Rinse hold = no final drain) is activated (depending on
the module). Resume the program by0
Spin/Drain
pto
choose and press
Start/Refill
to push.
The temperature in the drum is too high to open the door.
The safety function is activated. Stop program? The water
level in the drum is too high.
Can the door only be opened with the emergency release?
■
■
■
■
The appliance does not fill
with water.
■
■
■
The program does not
start? Is the tap turned on?
Could the filter in the water supply be clogged?
The filter in the water supply is clogged" on page 47
No detergent is
dosed.
Note:
If an additional water filter is installed (depending on
the model), check it for contaminants and clean it if necessary
~separate installation and cleaning instructions for water filter.
Is the supply hose kinked or pinched?
■
50
