Engineer Programming Via the Keypad
77
Siemens Building Technologies
Fire Safety & Security Products
09.2008
10.12 Test
Programming options for Test are available from the Keypad under the TEST
menu in Tab. 21 listed below. Tab. 22 reveals its location in the Full Engineer
menu.
8
TEST
BELL TEST
WALK TEST
ZONE MONITOR
OUTPUT TEST
SOAK TEST
AUDIBLE OPTIONS
Tab. 21
System Options under the TEST Menu
0
SYSTEM STATUS
1
VARIABLES
2
TIMERS
3
AREAS
4
XBUS
5
WIRELESS
6
ZONES
7
OUTPUTS
COMMUNICATION
8
TEST
9
UTILITIES
Tab. 22
Location of TEST Menu in the Full Engineer Menu
The following section provides programming steps found within Test using the
Keypad. For each menu option, the Keypad must be in Full Engineer programming
and within the menu option TEST:
1.
Enter the Engineer Programming code
(default 1111).
2.
Press SELECT for FULL ENGINEER
programming.
3.
Using the up and down arrow keys, scroll to
the TEST programming option.
Î
An ellipsis (…) on accompanying graphics denotes when there is a choice of
menu selection by scrolling.
FULL ENGINEER
EXIT
SELECT
...TEST...
BACK
SELECT
