Siemens SITRANS FUH1010, Product Instruction Manual, Page: 69 / 264

Connecting
5.6 Sensor Installation
FUH1010 IP65 NEMA 4X Precision Volume
68
Operating Instructions, 01/2013, A5E32122003-AA
1. Perform all required menu programming steps up until the point where you respond to the
[Install Complete] prompt.
2. Make a note of the reported Number Index displayed in the [Install Sensor] menu. Check
to ensure that you have a matched set of sensors. They both should have the same serial
number but marked with either an "A" or "B" (e.g. 100A and 100B).
Note
Some sensors require a right-angle adapter. This adapter should be installed before
placing the sensors in the tracks.
3. Prepare pipe for the track mounts by degreasing the surface, if needed, and removing
any grit, corrosion, rust, loose paint or surface irregularities with the abrasive pipe
conditioning material provided.
4. Wrap the mounting strap around the pipe and through the strap guide of both tracks.
5. Finger-tighten the chain Tension Screw to secure the strap and tracks to the pipe.
Note
For easier installation, it may be helpful to use a tie, tape or bungee cord to hold the two
tracks in place while mounting.
Positioning Track Assemblies
1. Wrap the supplied Mylar guide around the pipe and alongside the track assemblies noting
the point of overlap with a marker.
2. Remove the guide; fold in half at the point of overlap creating a crease in the Mylar at the
halfway point. This crease will act as a location point where the track will sit centered 180
degrees on the opposite side of the pipe.
3. Re-install the Mylar guide ensuring alignment of the overlap point with the center of one
track.
4. Loosen the mounting straps enough to allow you to rotate the track assembly until the
center of one track aligns with the center line on the Spacer Guide and the center of the
other track aligns at the point where the Spacer Guide ends meet. Use the edge of the
Mylar guide to ensure the tracks are parallel. The tracks should now be 180° apart.
Tighten both straps (or chains, if provided).