Siemens SITRANS FUH1010, Product Instruction Manual, Page: 102 / 264

Functions
7.5 Analog Input Setup
FUH1010 IP65 NEMA 4X Precision Volume
Operating Instructions, 01/2013, A5E32122003-AA
101
Assigning a function to the voltage output:
1. From the [Analog Out Setup] menu, press <Right Arrow> to access the [Vo1] option list.
2. Move the cursor to the desired data function by pressing <Up/Down Arrow>.
3. To store selection press <ENTER>.
Note
Refer to drawing 1010N-7-7 for Analog output connections.
7.5 Analog Input Setup
The optional Analog Input Setup function assigns an active analog input to a measurement
channel/path. The flow meter provides four DC current input ports for single channel and
Dual Path units. The DC current input ranges from a zero level of 4mA to a full scale of
20mA. The [Analog Inp Setup] menu cell allows you to enable this port and then span it to
any desired scaling.
For example, when using the analog input viscosity function the numeric variables might be
spanned as follows: 4mA=1 (water) and 20mA=100 (more viscous liquid). This spanning
configuration allows the flow meter to use this constant numerical change to improve
calibration in real time.
The various flow meter models allow you to associate the analog input to active system
variables such as viscosity and others (see table below).
Note
Refer to the Installation Drawings or I/O Module markings for the locations of these inputs
and wiring procedures.
Table 7- 9 I/O Data Control Menu
Input Off
Aux
cS
cP
PSIA
BARA
T1 Deg F
T1Deg C
T2 Deg F
T2 Deg C Iin1
4 mA
20 mA Numeric entry
Numeric entry
I/O Data Control Analog Inp Setup
Iin2 / Iin3 / Iin4 See In1 option list