Siemens SITRANS FUH1010, Product Instruction Manual, Page: 117 / 264

Functions
7.10 Setting Relays
FUH1010 IP65 NEMA 4X Precision Volume
116
Operating Instructions, 01/2013, A5E32122003-AA
Relay 1, 2, 3, and 4 Function Assignments
The flow meter, depending upon the model, provides four alarm relays. Please refer to the
Appendix A (Page 163) for wiring details. Relays respond to any of the alarm conditions or
data functions included on the Relay Option List.
Table 7- 12 Relay Option List
Not Used Not Active
Power Off Power Off alarm occurs when power fails.
S High LiquIdent High LiquIdent value relay trip-point.
S Low LiquIdent Low LiquIdent value relay trip-point.
S High Viscosity High liquid viscosity value relay trip-point.
S Low Viscosity Low liquid viscosity value relay trip-point.
S High Temperature High temperature value relay trip-point.
S Low Temperature Low temperature value relay trip-point.
S High Flow System flow rate exceeds high flow set point.
S Low Flow System flow rate falls below low flow set point.
S Flow Alarm System flow rate exceeds or falls below flow set points.
S Fault Alarm System loses receive signal (all paths in fault).
S Spacing System sensor spacing needs adjusting.
S Empty Empty pipe alarm.
S BatchTot Batch/Sample total advances.
S Aeration Aeration percentage exceeds alarm set point.
S Interface Interface setpoint exceeded.
S Reverse Flow Flow is in negative direction.
S Pos Total Positive total volume advances 1 digit.
S Neg Total Negative total volume advances 1 digit.
S Fltwarn System fault warning occurs when 1 or more paths are in
fault.
S Soft Fault Fault condition - memory mode active.
S Pig Detect Pig detection value relay trip-point exceeded.
Note
For Multi-Path flow meters: "1" = Path 1, "2" = Path 2, and "S" represents the system or
average channel. These characters appear to the left of the option list parameter.