Siemens SIMATIC NET CP 343-2, Manual

Page: 116 / 140

A AS-Interface Protocol Implementation Conformance Statement (PICS)
116
CP 343−2 / CP 343−2 P AS−Interface Master
Release 08/2008
C79000−G8976−C149−04
Table K-2 PICS, (continued)
No. Comment / Function implemented by M4 Function or Call on the Host Interface
(symbolic representation)
7 Status = Store_Actual_Parameters() X see Section 5.2
8 Status =
Set_Permanent_Configuration(Addr,
Config) X see Section 5.2
9 Status, Config =
Get_Permanent_Configuration(Addr) X see Section 5.2
10 Status = Store_Actual_Configuration() X By pressing the SET button; also using a
command (see Section 5.2)
11 Status, Config =
Read_Actual_Configuration(Addr) X see Section 5.2
12 Status = Set_LPS(List31) X see Section 5.2
13 Status, List31 = Get_LPS() X see Section 5.2
14 Status, List31 = Get_LAS() X see Section 5.2
15 Status, List32 = Get_LDS() X see Section 5.2
16.0 Status = Get_Flags() X see Section 5.2
16.1 Status, Flag = Get_Flag_Config_OK() X see Section 5.2
16.2 Status, Flag = Get_Flag_LDS.0() X see Section 5.2
16.3 Status, Flag =
Get_Flag_Auto_Address_Assign() X see Section 5.2
16.4 Status, Flag =
Get_Flag_Auto_Prog_Available() X see Section 5.2
16.5 Status, Flag =
Get_Flag_Configuration_Active() X see Section 5.2
16.6 Status, Flag =
Get_Flag_Normal_Operation_Active() X see Section 5.2
16.7 Status, Flag = Get_Flag_APF() X CPerror bit, LED display;
(see Section 5.2)
16.8 Status, Flag = Get_Flag_Offline_Ready() X see Section 5.2
16.9 Status, Flag = Get_Flag_Periphery_OK() X see Section 5.2
17 Status = Set_Operation_Mode(Mode) X By pressing the SET button; also using a
command (see Section 5.2)
18 Status = Set_Offline_Mode(Mode) X see Section 5.2
19 Status = Activate_Data_Exchange(Mode) − optional command
20 Status = Change_Slave_Address(Addr1,
Addr2) X see Section 5.2
21.1 Status = Set_Auto_Address_Enable X see Section 5.2
21.2 Status = Get_Auto_Address_Enable X see Section 5.2