Siemens HiPath 8000, Administrator'S Manual

Page: 224 / 249

Alphabetical Reference
224
Terminal number
• The phone will send REGISTER messages containing the contents of
this parameter, but only when the Register by Name field
Æ
page 210
is set to "Off" and the SIP Routing field
Æ
page 216 is set to "Server".
• Whether this parameter is used, depends on the configuration of the
registrar server.
• Value range table:
• Editing by phone: Number Editor Æ page 157.
Æ
page 61
Æ
page 115
Terminating line preference
Terminating Line selection – provides connection of the phone to one of
the lines appearing on it, on an automatic basis when calls are alerting or
ringing (audible) and the user goes off-hook. There are five terminating op-
tions.
A Keyset is assigned one of the following preferences.
•
Ringing Line Preference – A line in the ringing state is selected for ter-
minating calls. In the case of multiple lines, lines shall be selected on a
first-in, first-out basis.
• Ringing Line Preference with prime line preferred – Same as Ring-
ing Line Preference, but if the prime line is ringing at any time it is sig-
naled and selected before calls on secondary lines.
•
Incoming Line Preference
– In the case of multiple lines alerting or
ringing on a device, an incoming line is selected based on its ringing as-
signment. Ringing lines are selected on a first-in, first-out basis first,
then alerting (visual only) lines are selected on a first-in, first-out basis.
•
Incoming Line Preference with prime line preferred
– Same as In-
coming Line Preference, but if the prime line is ringing at any time it is
signaled and selected before calls on secondary lines. Prime line must
have ringing arrangement.
• No (Terminating) Line Preference – A line key must be pre-selected
or post-selected each time the user elects to answer a call.
Select the according terminating line preference:
– Ringing
– Incoming
– Incoming PLP
– Ringing PLP
– None
See also Originating line preference on Æ page 204.
Æ page 69 Æ page 123
Permitted values numeric
Length min. 1 digit
Length max. 20 digits