2
General Information
This manual describes the drive amplifiers of the series SD2B plus. These devices al-
low operation of high-dynamic servo motors as well as synchronous and asynchronous
high-frequency spindles.
The devices are equipped with interfaces for different sensor systems and allow the op-
eration of motors with Hall and incremental sensors. Motor systems without any sensors
are also supported, whereas different customized control methods are available. In ad-
dition, the devices can drive rotary and linear motors. Thus, the number of device vari-
ants is reduced for the machine manufacturer.
This manual provides information on:
▸
Safety instructions and application advice
▸
Notes about the electromagnetic compatibility
▸
Description of the device (block diagram, type plate, module designation)
▸
Technical data, dimensions
▸
Connector pin assignment
▸
Wiring examples
▸
Status and error messages
▸
General information regarding the wiring (cables and line cross-sections)
This manual has the following demands on the trained staff of machine manufacturers:
Transport:
only by skilled employees familiar with handling electrostatically sensitive compo-
nents
Installation:
only by experts with electrotechnical training
Initial operation:
only by experts with experience in the fields of electrical engineering / drive technol-
ogy
Note
Information concerning the initial operation and parameterization of the digital drive am-
plifier can be found in the manual of the software
drivemaster 2
.
Note
More documentation can be downloaded from the SIEB & MEYER website under
www.sieb-meyer.de/downloads.html
.
2.1
Approval for the Markets in USA and
Canada
Using products in public buildings or industrial environments in the USA or Canada must
be conform withe the applicable national regulations. In particular electric products and
machines are subject to testing and certification obligations and shall be labeled specif-
ically.
The Occupational Safety and Health Administration (OSHA) only accepts devices that
have been approved by an authorized NRTL laboratory (Nationally Recognized Testing
Laboratory) and labeled with an appropriate test mark. An NRTL authorized by OSHA
checks the legitimate status of the test mark by inspectors of the manufacturing sites,
for example.
7
Drive Amplifier SD2B plus - 0362171DA1xxxx, 0362171DB1xxxx
General Information
