Technical data
Rated value
Storage temperature
-40 to 70 °C
Operating temperature
-20 to 70 °C
Between optical fiber cable and connector
19.6 N
Tensile stress
Optical fiber cable
49 N
Bending radius
(1)
Min. 25 mm
(1)
When bending the optical fiber cable to install it, note that the recommended bending radius is six
to ten times greater than the minimum bending radius.
Procedure
1. Remove at least 7 mm of the optical fiber cable's plastic sheat (diameter 2.2 mm);
see figure, [1]). Take care that the dismantled end of the optical fiber cable is not
contaminated. If necessary, clean it gently with a dry tissue paper.
2. Insert the dismantled optical fiber cable carefully as shown in the figure into the con-
nector. The polymer fiber of 1 mm should stand out from the connector about 1 to
2 mm (see figure, [2]).
3. Press the clip of connector so that the polymer fiber is hold in the connector. The
connector and the clip must interlock audibly (see figure, [3]).
4. Insert the connector with the optical fiber cable into a polishing disk and grind the
outstanding end of the fiber by means of a polishing sheet on an even surface (e.g.
glass sheet), see figure, [4]). Remove grinding residues.
You can order the following materials at SIEB & MEYER:
Article
SIEB & MEYER article number
Polishing disk for optical fiber cables
47000001
Dismantling tool for optical fiber cables
47000002
Grinding paper
47000003
31
Drive Amplifier SD2B plus - 0362171DA1xxxx, 0362171DB1xxxx
Connector Pin Assignment
