7
Connector Pin Assignment
7.1
X58 – USB Connector
The operating terminal is connected to the PC via the USB connector. When the oper-
ating terminal is in the USB TRANSPARENT MODE, you can operate the drive via the
drivemaster2
software.
5-pole female USB connector, type: Mini-B
X58
Pin
I/O
Name
1
n.c.
2
I/O
D-
3
I/O
D+
4
n.c.
5
I/O
GND
7.2
X59 – COM2 Interface (RS232)
Via the COM2 interface, you can establish an RS232 connection between the operat-
ing terminal and the PC. When the operating terminal is in the RS232 TRANSPARENT
MODE, you can operate the drive via the
drivemaster2
software.
The connection for the boot loader is used by the SIEB & MEYER service staff for load-
ing new operating terminal software. If you want to load a new software into the operat-
ing terminal, please contact the SIEB & MEYER service.
9-pole male D-sub connector
X59
Pin
I/O
Name
Description
1
E
VCC5
5 V voltage supply
2
E
PC-RX
Receive data
3
A
PC-TX
Transmit data
4
n.c.
5
I/O
GND
Ground
6
n.c.
7
n.c.
8
n.c.
9
I/O
Boot loader
Connection for boot loader
Stud bolt flange: max. tightening torque = 0.7 Nm
7.3
X60 – USB Download Socket
The USB download socket is a 6-pole row of holes and is used by the SIEB & MEYER
service staff to load a new operating terminal software. If you want to load a new soft-
ware into the operating terminal, please contact the SIEB & MEYER service.
13
Drive System SD2x - Operating Terminal 0362150 and 0362153
Connector Pin Assignment
