1
After starting, the device loads the last permanently stored internal parameter set
to its working memory.
2
The device then searches for a valid parameter set in the optional memory card
slot. If there is a positive search result, the device overwrites the existing parame‐
ter set in its working memory with this parameter set. The device starts with the
new parameter set.
3
Centralized configuration of the nodes via PROFINET: When the PROFINET con‐
troller sends the parameter set of the device, the device temporarily overwrites
the relevant parameter values in its working memory. These changes are lost
again when the device is switched off. The PROFINET controller must then resend
the valid parameter values each time the device is restarted (supply voltage is
switched on).
Removing the memory card from the device:
NOTICE
Risk of damage to the memory card
b
To safely install or uninstall the memory card, insert or remove the card only
when the device is
de-energized
. To do this, disconnect the device from the supply
voltage beforehand.
1.
Switch off the supply voltage to the device.
2.
Open the black rubber cover.
To do so, carefully lift the flap of the rubber cover.
3.
Unlock the memory card in the slot and remove it.
To do so, carefully press down once on the memory card.
4.
Close the rubber cover. Make sure that the cover is completely flush with the
housing.
5.
Switch on the supply voltage for the device.
Support Portal
NOTE
In the SICK Support Portal (
, registration required) you will find,
besides useful service and support information for your product, further detailed infor‐
mation on the available accessories and their use.
3
PRODUCT DESCRIPTION
26
O P E R A T I N G I N S T R U C T I O N S | CLV61x DualPort (PROFINET)
8017842/19XD/2021-11-19 | SICK
Subject to change without notice
