O P E R AT I N G I N S T R U C T I O N S |
Bulkscan LMS511
8014829/ZNC5/2017-06-06 |
S I C K
Subject to change without notice
2 8
CONFIGURABLE FUNCTIONS
If you change the parameters for the interface via which you are connected to the sen-
sor, the connection to the sensor will be lost. You must re-establish the connection (see
"7.1.2 Establishing communication with the Bulkscan“ on page 50).
To connect the electrical interface, (see "6.2.4 Serial interface connection“ on page
4.15.3
Serial auxiliary interface/USB
The Mini-USB Interface permits the direct configuration of the Bulkscan.
•
Configuration via USB is only possible if you have installed the USB driver during the
installation of the SOPAS configuration software. This is the case with the default
installation.
• Parameters can then also be changed via USB, if the Bulkscan is connected to a
host via another interface. Only the changes last saved in the sensor are retained.
The
Data transmission rate
and
Heartbeat rate
of the USB interface can be configured
via software.
Network
tab,
Interfaces, Serial, Serial auxiliary interface/USB
group
To connect the electrical interface, (see "6.2.5 Mini-USB connection“ on page 41).
Note
