![background image](http://html1.mh-extra.com/html/sick/1106166/1106166_operating-instructions-manual_1264410112.webp)
Table 42: Test control standard SFNC parameters
Parameter
Type
Description
Access
TestPayloadFormatMode
enum
Tests the device's pending acknowledge feature.
Values:
Off
MultiPart
TestPendingAck
RW
Table 43: Test control standard SFNC command
Command
Description
Access
TestEventGenerate
Generates a Test Event.
Used for GenICam standard compliance event testing.
W
16.2.14
Transport layer control
The user cannot edit these features.
Table 44: Transport layer control standard SFNC parameters
Parameter
Type
Description
Access
PayloadSize
int
Provides the number of bytes transferred for each image or
chunk on the stream channel.
R
16.2.14.1
GigEVision
Normally, the user must not edit these features. Changing them can cause errors.
Table 45: GigEVision control standard SFNC parameters
Parameter
Type
Description
Access
GevMCPHostPort
int
Controls the port to which the device must send messages.
R
GevMCDA
int
Controls the destination IP address for the message channel. R
GevMCTT
int
Provides the transmission timeout value in milliseconds.
R
GevMCRC
int
Controls the number of retransmissions allowed when a mes‐
sage channel message times out.
R
GevMCSP
int
Indicates the source port for the message channel.
R
GevSCPHostPort
int
Controls the port of the selected channel to which a GVSP
transmitter must send data stream or the port fromwhich a
GVSP receiver may receive data stream.
R
GevSCPSPacketSize
int
Specifies the stream packet size, in bytes, to send on the
selected channel for a GVSPtransmitter (set by negotiation
between the device and PC during connection) or specifies
the maximum packet size supported by a GVSP receiver.
R(W)
GevSCPD
int
Controls the delay (in GevTimestampTickFrequency) to insert
between each packet for this stream channel.
This feature can be used as a crude flow-control mechanism
if the application or the network infrastructure cannot keep up
with the packets coming from the device.
RW
GevSCDA
int
Controls the destination IP address of the selected stream
channel to which a GVSP transmitter must send data stream
or the destination IP address from which a GVSP receiver may
receive data stream.
R
GevSCSP
int
Indicates the source port of the stream channel.
R
MultiPartSupport
bool
Manual Enable/Disable of multipart-configuration bit (25) in
SCCFGx register for testing.
RW
GevMACAddress
int
MAC address of the logical link.
R
16
ANNEX
112
O P E R A T I N G I N S T R U C T I O N S | Ruler3000
8026049//2021-04 | SICK
Subject to change without notice