User manual GC600-GC600
Mains
21
Page
M.11 (SYNCHRONIZATION)
displays synchronization information. The use of the displayed
synchronoscope in MAN mode allows the manual synchronization (par. 6.2.1).
Page
M.12 (PARALLEL)
displays the information when the genset is in parallel with the mains or other
gensets. It displays the active and reactive power and the power factor. It also displays currents,
medium
voltage
and
genset
frequency.
In this page it is possible to change the power supplied in the application of parallel with the mains
BASE LOAD
and
IMPORT/EXPORT
Page
M.13 (SETPOINTS)
shows and allows to modify (in a unique point) all setpoints applicable for
plant, relative to speed and voltage governor.
The setpoints are shown only if are not acquired by analogue inputs and are provided in the plant
configuration.
Page
M.14 (SETPOINTS 2)
shows (in a unique point) all setpoints applicable for plant, relative to speed
and voltage governor, acquired by analogue inputs.
INFORMATION! Some of the data is not displayed in mono-phase configuration.
The engine related measurements are shown in this mode.
Page
E.01 (ENGINE 1)
displays the main values of the engine: Oil pressure (bar), Coolant temperature
(°C) and engine speed (rpm).
If any of these values is not available, it’ll be replaced with dashes. Under some electrical measures,
the controller also displays a bar showing graphically the value measured compared to the full-
scale: on the bar are also one or more notches representing the eventual thresholds. The colour
with which the band is filled is green if the measure is in tolerance (shutdown), yellow if the measure
is out of tolerance (for warning).
Page
E.02 (ENGINE 2)
displays the starter battery voltage (V), the fuel level (%) and the oil temperature
(°C).
If any of these values is not available, it’ll be replaced with dashes. Under some electrical measures,
the controller also displays a bar showing graphically the value measured compared to the full-
scale: on the bar are also one or more notches representing the eventual thresholds. The colour
with which the band is filled is green if the measure is in tolerance (shutdown), yellow if the measure
is out of tolerance (for warning).
Page
E.03 (ENGINE COUNTERS)
displays the starter and hours of work counter (partial and total hours,
load hours, Override and hours until the next maintenance).
The number of pages displayed may depend on the type of engine (
J1939
,
MTU
or
without
communication interface
).
Pages
E.04, E.05, E.06, E.07, E.08, E.09 (CANBUS 1...6)
display a series of information acquired via
CAN-BUS by the engine (or via RS485 for some CUMMINS engines). The number and type of
available measures depend on the engine type. The information not available are shown with some
dashes. The measures are acquired only if the CAN-BUS communication with engine has been
enabled.
INFORMATION! The display of some parameters depends on the engine model used. If some
information is not available, some pages might not to be visible.
The
E.10 FUEL PUMP
(FUEL PUMP)
page (available only if the fuel pump management output is
configured) contains information and commands for the fuel pumps.
The pages
E.11-12-13
(EXTERNAL MEASURES)
display the measures acquired by the analogue
inputs configured as generic sensors. The controller shows one measure per line: it shows the
