User manual GC600-GC600
Mains
15
•
The maximum and minimum time of exposition. These times are automatically reset when
the PLC program is transferred to the controller or it is possible to force the reset by pressing
the buttons
ACK/ENTER
+
Esc/SHIFT
for 5 seconds.
The page
L.02 (PLC LOGIC)
contains the information related to the single PLC block.
The selected block is shown with format “TIPO-NUMERO”
(1) in the second line of the display.
In the example we have a block called “AND-001”.
In the next lines all parameters of the selected block are shown (one line for each parameter):
•
The first column (2) identifies the parameter type of the block (input or output). In the
example, the block AND-001 has two inputs <in> and one output <out>.
•
The second column (3) identifies the resource associated to the block parameter. In the
example, the block AND-001 has two physical inputs of the GC600 controller
(DI_CONTROLLER_01 and 02) associated to its inputs (<in>) and the result of the logic is
withdrawn from the output <out> of the block and transferred on a virtual digital input
(DI_VIRTUAL_01) of the controller.
•
The third column (4) shows the current value of the resource. As for the digital resources, if
the value is displayed in REVERSE, this means that the relative parameter is denied.
Page
L.03 (VIRTUAL INPUTS)
shows the status of all virtual digital inputs (that is, those inputs which
status is not acquired by the hardware, but it is determined by the PLC program).
Page
L.04 (DIGITAL FLAGS)
shows the status of all digital temporary variables available for the PLC
program. There are more pages that alternate every 2 seconds to display all the digital supports.
If you keep
Esc/SHIFT
button pressed, the rotation of pages is stopped (keeping on the
display the page currently shown).
Page L.05
(DIGITAL STATE)
shows the value of all controller internal statuses (ST.XXX) available for
the PLC program.
Page
L.06 (VIRTUAL ANALOGUE)
shows the status of all virtual analogue inputs (that is, those inputs
which the heat is not acquired by the hardware, but it is determined by the PLC program).
Page
L.06 (NUMERICAL SUPPORT)
shows the status of all numeric temporary variables (AT_XXX)
available for the PLC program. There are more pages that alternate every 2 seconds to display
all the numerical supports. If you keep
Esc/SHIFT
button pressed, the rotation of pages is
stopped (keeping on the display the page currently shown).
L.02 LOGIC PLC _
PLC Block: [AND-001]
| |
<out>|DI_VIRTUAL_01 | 0
<in> |DI_CONTROLLER_01 | 1
<in> |DI_CONTROLLER_02 | 0
| |
| |
| |
| |
2
3
KEY:
1 - Identification
2 - Parameter type
3 - Associated resource
4 - Resource value
4
1
