− 15 −
CAUTION
CAUTION
ａ
Install the Mistresa level so that oil properly drains from the unit.
ｂ
Using bolts and nuts, connect the Mistresa to the machine/equipment.
(CRM-V series Mistresas do not require a duct hose or drain tube.)
ｃ
Ensure about 500 mm of clearance on all sides of the Mistresa for
checks, maintenance and parts replacement.
Outside of machine/
equipment
Machine/
Equipment
Inside of machine/
equipment
(2) Power supply connection
WARNING
①
Be sure that the power supply conforms to the rated voltage and rated
frequency requirements.
• When using inverter controlled operation, protect the motor by
incorporating the motor burnout prevention terminals "A" and "B"
in the inverter's control circuit.
In addition, if it is inverter operation at different voltage (more
than 380V), you will need a motor insulation strengthening.
• Permissible voltage fluctuation range:
Continuous…Rated voltage within ±5%
Momentary…Rated voltage within ±10%
②
Please connect the
ground wire
sure.
③
CRH Series: The impeller rotates clockwise when viewed from the
motor. Make sure that impeller rotates in the correct
direction before starting operation.
CRM-S Series, CRM-V Series, and CRMH-S Series
: The impeller can rotate either clockwise or
counterclockwise direction.
Summary of Contents for Mistresa CRH Series
