18
HOW TO SET DIP SWITCH
EXAMPLE ONE:
1. Mode 145 means the Dip Switch pin #1, #4 & #5 should be set to the
“ON”
(UP) positions.
2. SB-3403 Output Connections:
•
SB-3403 TV1 output is connected to #1 LCD
•
SB-3403 TV2 output is connected to #2 LCD
•
SB-3403 TV3 output is connected to #3 LCD
•
SB-3403 TV4 output is connected to #4 LCD
3. LCD panel should be installed in the directions shown in the picture below.
EXAMPLE TWO:
Mode 124–75° Counterclockwise Rotation (Ratio 1.77):
(#4 output will show full screen image)
1. Mode 124 means the Dip Switch pin #1, #2 & #4 should be
set to the
“ON”
(UP) positions.
2. SB-3403 Output Connections:
•
SB-3403 TV1 output is connected to #1 LCD
•
SB-3403 TV2 output is connected to #2 LCD
•
SB-3403 TV3 output is connected to #3 LCD
•
SB-3403 TV4 output will show full screen content for
system monitoring.
EXAMPLE THREE:
Mode 06A – 1x3 (Ratio 1.69):
Please apply a 90° rotation to the image content to get the normal viewing angle. If the content is not at a
90° rotation, then the user needs to create a custom mode or rotate the image in the
[Orientation]
menu setting.
1. Mode 06A means Dip Switch pin #6 should be set to the
“ON”
(UP) positions.
2.
“A”
means this mode is can only be achieved by rotating the image from the signal source. If
the image is not rotated from the signal source, then it is necessary to rotate the image with the
SB-3403 through the
[Orientation]
menu. Please also pay attention to the content aspect ratio.
3. SB-3403 Output Connections:
•
SB-3403 TV1 output is connected to #1 LCD
•
SB-3403 TV2 output is connected to #2 LCD
•
SB-3403 TV3 output is connected to #3 LCD
•
SB-3403 TV4 will show full screen image same as signal source.
