11
PIP/POP SETTING
A. PIP INPUT SELECTION:
Users can use the Dip Switch to select the PiP/PoP input source from the HDMI, DVI, DP & VGA input ports.
B. PIP/POP MODE SELECTION:
Direct selection from the
[PiP Setting]
Dip Switch.
C. PIP SIZE AND LOCATION:
• Preset Size:
Max 1024x768 resolution (100%)
• Preset selection from the Dip Switch:
25%, 50%, 75%, 100%
• Preset Location:
(7) positions across the video wall can be selected from the Dip Switch. The Dip Switch positions are as follows:
Top Left (3), Top Right (34), Bottom Left (5), Bottom Right (4), Center up (35), Center (00), Center Down (45)
NOTE:
1. After the Dip Switch selection, users need to Power OFF/ON the unit again to implement the settings.
2. Users can continuously adjust the PiP size and location via the remote control.
3. Please adjust the aspect ratio of the PoP image under
[Image Properties]→[Scaling].
4. Entire video wall dynamic aspect ratio changes in the H&V directions can be implemented in the Manual Display Mode but not
in the Preset modes.
PiP (Picture in Picture) mode
“PoP Raw” display mode
“PoP Full” display mode
Please adjust the aspect ratio of PoP image under
[Image Properties]
menu while using remote control.
