46(65)
2) Firstly fit coupling 2 on cutter shaft to match key groove holes with the cutter
shaft key. And then fasten the coupling via inner hex flat end set screw.
Picture 3-7: Installation of Gear Motor 2
3) Tightly fit coupling 1 and 2, fasten them on bottom plate via bolts and then
fasten them on the bottom plate via cover plate.
Notice!
Do not apply lubricating oil on bearing and bearing base.
Notice!
To stop blade rest shaft rotating while coupling mount and installation,
use a thick wood block to stuck rotate blades!
Caution!
The cutting blade rest shall be put stably and avoid cutter self-rotation.At
the time of operating, hand shall stay away from the cutting tool to avoid
bodily injury.
3.5 Installation of Rotating Blade and Fixed Blade
Attention!
Blades are extremely sharp; to avoid injuries, please waer gloves before
and during installation.
Installation Steps:
1) Install the bearing 2, bearing washer 1, bearing sleeve 7 into the bearing
base 3.
2) Insert the blade shaft 4 into the bearing sleeve vertically 7. Then sleeve the
staggered blade 5 and the teeth blade 6 on the bearing spacing.
Summary of Contents for SG-24T
