Secure the drum
axle to the shaft
Install drum
axle onto
output shaft
Drum
Axle
Cotter
Pin
Hitch
Pin
Clevis
Pin
Install the sweeper drum
assembly
Drum
Assembly
3
Secure with a
cotter pin
1
2
4
7
Assembly
(continued)
The PowerBroom tool should now
be completely assembled.
Push one of the drum axles onto either
1.
of the two gearcase output shafts. If
necessary, rotate the drum axle until
the clevis pin hole in the axle aligns
with the matching hole in the gearcase
output shaft.
CAUTION!
The two drum assemblies are identi-
cal, but each drum must be installed
with its recessed end facing toward
the gearcase.
Sweeper Assembly
(sold separately)
Use a clevis pin and hitch pin to secure
2.
the drum axle to the shaft.
Slide the recessed end of a sweeper
3.
drum assembly over the installed axle,
and then push the drum down the axle
until the cotter pin hole in the axle
extends above the drum surface.
Use a cotter pin to secure the drum
4.
assembly on the axle (see inset). The
cotter pin is designed to fit tightly
against the outboard end of the drum,
so you may need to compress the drum
face slightly during installation. spead
the ends of the cotter pin to secure.
Repeat Steps 1-4 to install the remain-
5.
ing axle and drum assembly.
