8
Handle C3410
1. Use the 4 mm hex wrench to remove
the lower cap retaining screws from
the handlebar bracket. Remove the cap
from the bracket, and note the position
of the two spacers installed between the
bracket halves. See Figure 13.
2. Position the handle on the outer tube
forward of Handle Positioning Label
as shown in Figure 12. Reassemble the
lower cap to the handlebar bracket in
the reverse order of disassembly.
3. Locate the handle in the best position for
operator comfort.
4. Firmly tighten both lower cap retaining
screws.
5. Secure the cable to the outer pipe with
the 2 bands as the illustration shows.
The 2 bands are in the tool bag.
Figure13
Handlebar
Spacer
Spacer
Lower Cap
Retaining Screws
Lower Cap
Handle Positioning Label
Engine
C3410
Attach handle on this line.
Handle T3410
1. Put the 4 square nuts into the frame of
the barrier. See figure 12.
2. Fit the handle and barrier over the outer
pipe and tighten the 4 bolts.
3. Position the handle about 250 mm ahead
of the throttle housing end.
4. Secure the handle by alternately tight-
ening the four bolts in a diagonal or
“crisscross” fashion.
Figure 12
Barrier
Square Nut
Handle
Bolt
Barrier
About 250 mm
Handle
Assembly and Adjustments
