Shindaiwa 22F, Owner'S/Operator'S Manual

Page: 7 / 44

7
Trimmer Head Installation
Assembly
Output
Shaft
Tool Holder
Gearcase Notch
Install Trimmer Head
COUNTER CLOCKWISE (22T),
CLOCKWISE (22F)
Spacer
1. Position the trimmer with the gearcase
output shaft pointing up; as shown in
the illustration.
. Install the spacer onto the
output shaft.
3. Install the tool holder and align the
hole on the side of the holder with the
notch on the gearcase; as shown in the
illustration.
4. Insert a 4 mm hex wrench through the
tool holder hole and the gearcase notch
to lock the tool holder to
the gearcase.
5. While holding the tool holder locked
with the 4 mm hex wrench, thread the
trimmer head onto the
output shaft.
6. Remove the hex wrench to unlock the
tool holder. Rotate the trimmer head by
hand to ensure that it does not bind and
rotates freely.
Figure 9
WARNING!
A standard grass trimmer
with a loop handle should NEVER be
operated with blade-type attachments.
WARNING!
NEVER operate the 22T
without the cutting attachment shield
installed and tightly secured!
WARNING!
The line cutter is very sharp.
Wear gloves to protect your hands
when handling.
To Change Position of Line Cutter.
1. Remove the hex screws with a 4mm
hex wrench. See Figure 8A.
. Rotate line cutter. See Figure 8A.
3. Reinstall the two hex screws and tighten
them securely.
NOTE:
Be careful to not lose the 2 nuts in the
cutting attachment shield, they are
not captured.
The line cutter can be positioned in
positions to obtain different line length
for cutting.
ENGLISH
22T Cutting Attachment Shield Installation
Assembly and Adjustments
1025
Figure 8
Cutting
Attachment
Shield
Outer
Tube
Socket-
Head Cap
Screw
Bracket
Shim
Clamp
Screw
Shim
Retaining
Nut
Cutting
Attachment
Mounting
Plate
Line Cutter
Figure 8A
Hex
Screws
Nuts
CAUTION!
Make sure the clamp screw and
retaining nut are securely tightened
before tightening the four socket head
cap screws .
Install the Cutting Attachment Shield.
1. Insert the cutting attachment shield
between the outer tube and the cutting
attachment mounting plate.
See Figure 8.
NOTE:
It may be necessary to loosen the retaining
nut and clamp screw to adjust cutting
attachment shield mounting plate.
. Fit the two shims and the bracket over
the outer tube and loosely install the
four socket-head screws.
See Figure 8.