6
Adjust Throttle Lever Free Play
Assembly and Adjustments
Handle
Assembly and Adjustments
ENGLISH
Handle.
1. The handle is attached to the outer
tube at the factory and positioned
vertically. See Figure 5.
. Loosen the 4 screws on the handle
and rotate the handle 90 degrees. See
Figure 5.
3. Position the handle forward of the
Handle Positioning Label at the best
position for operator comfort (usually
about 10 inches ahead of the throttle
housing).
4. Secure the handle by alternately
tightening the four screws in a diagonal
or “criss-cross” fashion.
Handle
Outer Tube
Screws
Figure 5
Adjust Throttle Free
Play
The throttle lever free play should be
approximately 7 mm. Make sure that the
throttle lever operates smoothly without
binding. If it becomes necessary to adjust
the lever's free play, refer to the illustration
and proceed as follows:
1. Loosen the cable jam nuts to free the
cable from the support.
. Adjust the jam nuts until the throttle
lever has approximately 7 mm of
free play.
3. Tighten the jam nuts to secure the
cable assembly to the support.
22010A
Throttle Lever Free Play
7 mm
Throttle Lever
Jam Nuts
22011
Figure 6
22F Cutting Attachment Shield Installation
Assembly and Adjustments
22F
Screw (2 used)
Cutting
Attachment
Shield
1. Install the shield and clamp as shown in
Figure 7.
. Align the hole in the outer tube with the
locator on the cap; install the two ()
screws finger tight.
. Tighten the screws alternately to
secure the cutting attachment shield in
place.
Figure 7
Handle Positioning Label
WARNING!
NEVER operate the 22F
without the cutting attachment shield
installed and tightly secured!
Handle
Locating Hole
Outer Tube
Cap
Summary of Contents for 22F
Page 43: ...43 NOTES...
